Thin Twin WasheraDryer - 240 Volt Installation Instructions IMPORTANT: Read and save . her IMPORTANT: Installer: Leave Installation Instructi
Before you start... Check location where washer/dryer will be installed. Proper installation is your responsibility. The washer/dryer must
For use where local codes permit use of flexible power supply cord. four-wire three-wire receptacle(l4-30R) receptacle(lO-30R) Figure 3 Figure
center silver-colored terminal block screw \ neutral (white 01 center) Efl,appliance harness grounding 3Y/ e] St@+) cabinet- n external cabinet-
The exhaust duct can ’ be routed up, down, left, right or straight out the back of the washer/dryer. Space requirements are provided on
Do Not Remove Numbers CarreSDOnd to steljs. 9 n Remove the two rear corner posts located at the back of the washer/dryer* Remove the two rear
Move washer/dryer to its permanent location. Remove cardboard/hardboard from under washer/dryer. access panel in Step 19, remove the two fo
Recessed and closet installation instructions r* --I - * f ront view side view Mlnlmum lnstallatlon spacing Fire Hazard It is recommended that
If washer/dryer does not operate., Check the following to be sure that: 1. Electrical supply is connected. 2. House fuse or circuit brea
Comentarios a estos manuales