Whirlpool ACM 712/IX Instrucciones de uso descargar pdf (Pagina 3)

EN3

After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.

PREPARING THE CABINET FOR FITTING

Connection to the terminal block

For the electrical connection, use an H05RR-F cable as specified in the table below.

INSTALLATION

WARNING

- Install a separator panel under

the hob.

- The lower part of the product

must not be accessible after

installation.

- In case of installation of an

undertop oven, do not interpose

the separator panel.

• The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure.

• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).

• If an oven is installed beneath the hob, make sure the oven is equipped with a cooling system.

• Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them.

• To remove the hob from the worktop use a screw driver (not supplied) unlocking the springs from the bottom side of the appliance.

ELECTRICAL CONNECTION

WARNING

- Disconnect the appliance from the power supply.

- Installation must be carried out by qualified personnel who know the current safety and

installation regulations.

- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the

regulations provided in this chapter.

- The power cable must be long enough to allow the hob to be removed from the worktop.

- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home.

Wires Number x size

220-240 V ~ +

3 x 4 mm

220-240 V 3 ~ +

4 x 1.5 mm

380-415 V 3N ~ +

5 x 1.5 mm

380-415 V 2N ~ +

4 x 1.5 mm

Important:

- Based on the wiring diagram (see figure) either keep or remove the metal

jumpers between the screws on the terminal block L1-L2 and N1-N2.

- Make sure all six screws on the terminal block are tightened after connecting the cables.

-Example of jumper present (left) or removed (right). See the wiring diagram

for details (the jumpers can be between L1-L2 and between N1-N2).

min 5 mm

min 20 mm

min 5 mm

230 V

380-415 V 3N ~ 220-240 V ~ 220-240 V ~ (AU and UK)

380-415 V 2N ~

220-240 V 3 ~ (Belgium only) 380-415 V 2N ~ (Holland only)

CBA

400010780191.book Page 3 Thursday, March 12, 2015 11:39 AM

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios

Whirlpool ACM 712/IX Instrucciones de uso Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool ACM 712/IX