Whirlpool ACM 843/LX Instrucciones de uso descargar pdf (Pagina 8)

EN16

After unpacking the hob, check that there has been no damage during transport. If in doubt, contact the dealer or After-sales Service.

PREPARING THE HOUSING UNIT

Connecting to the terminal board

For electrical connection, use an H05RR-F cable as specified in the table below.

Connect the yellow/green earth wire to the terminal with the symbol .

This wire must be longer than the other wires.

1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).

2. Remove approx. 70 mm of sheath from the power supply cable.

3. Remove approx. 10 mm of sheath from the wires. Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in

the diagram next to the terminal board itself.

4. Secure the power cable with the cable clamp.

5. Close the cover (C) and screw it on the terminal block with the removed screw - point (1).

Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds.

If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means of an all-

pole disconnect switch with minimum contact gap of 3 mm.

INSTALLATION

WARNING

- Install a separator panel under the hob.

- The lower part of the product must not be

accessible after installation.

- If there is an oven beneath the hob, do not

install the seperator panel.

• For the distance between the underside of the appliance and the separator panel below, observe the dimensions given in the figure.

• Do not obstruct the minimum required clearance between the hob and the top of the unit to ensure the correct operation of the product.

• Cut the worktop to fit before installing the hob and carefully remove any shavings or sawdust.

• In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.

• To remove the hob from the worktop use a screw driver (not supplied) unlocking the springs from the bottom side of the appliance.

ELECTRICAL CONNECTION

WARNING

- Disconnect the appliance from the mains power supply.

- The appliance must be installed by a qualified technician who is fully aware of current safety and

installation regulations.

- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the

regulations provided in this chapter.

- The power supply cable must be long enough to allow the hob to be removed from the worktop.

- Make sure the voltage specified on the appliance rating plate is the same as that of the house electrical system.

- Do not use extension leads.

Conductors Amount x size

220-240 V ~ +

3 x 4 mm

230-240 V ~ +

3 X 4 mm

(Australia only)

220-240 V 3 ~ +

4 X 1.5 mm

380-415 V 3N ~ +

5 X 1.5 mm

380-415 V 2N ~ +

4 X 1.5 mm

min. 5

min. 20

min. 5

380-415 V 3N ~ 220-240 V ~

230-240V ~ (Australia only)

220-240 V ~ (UK only)

380-415 V 2N ~ 220-240 V 3 ~ (Belgium only) 380-415 V 2N ~ (NL only)

230 V

CBA

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Whirlpool ACM 843/LX Instrucciones de uso Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool ACM 843/LX