Whirlpool ACM 868/BA/IXL/N Instrucciones de uso descargar pdf (Pagina 6)

EN8

Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable if not magnetically detectable.

- Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.

- Never place hot pots or pans on the surface of the hob’s control panel. This could result in damage.

Place the pot on the required cooking zone before switching the hob on.

For good cooking results, the diameter of the base of the pot should match the size of the hotplate.

Pan size

To determine the size of the pot please measure the base of the pot (see picture) and refer to recommended pots bottom width table,

reported below, for perfect usage and correct pan detection. Each cooking zone has a minimum limit of detecting pans, which varies

depending on the material of the pan being used. You should therefore use the cooking zone that is most suitable for the diameter of

your pan.

After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.

For built-in dimensions and installation instruction, see the pictures in page 2.

PREPARING THE CABINET FOR FITTING

EXISTING POTS AND PANS

RECOMMENDED POT BOTTOM WIDTHS

Diameter (cm) Max (cm) Min (cm) Diameter (cm) Max (cm) Min (cm)

14.5 14.5 10 28 28 17

18 18 12 Oval 23 - 18 12

21 21 15 Flexizone 23 - 40 12

24 24 15

26 26 17

INSTALLATION

WARNING

- Install a separator panel under

the hob.

- The lower part of the product

must not be accessible after

installation.

- Do not fit the separator panel if

an undertop oven is installed.

• The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure.

• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).

• If an undertop oven is installed, make sure the oven is equipped with a cooling system.

• Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them.

• In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.

• To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance.

NOOK

min. 5 mm

min. 20 mm

min. 5 mm