Whirlpool ACM795BA Instrucciones de uso descargar pdf (Pagina 7)

EN 17

BEFORE USE

IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol “INDUCTION

SYSTEM“ (Figure opposite). Place the pot on the required cooking zone before switching the hob on.

EXISTING POTS AND PANS

NOOK

Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable if not magnetically

detectable.

• Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.

• Never place hot pots or pans on the surface of the hob’s control panel. This could result in damage.

RECOMMENDED POT BOTTOM WIDTHS

18 cm

14 cm 18 cm

30 cm

XLM

14 cm (Dual zone)30 cm

IMPORTANT: refer to the “SIXTH SENSE Function“ section for correct pan base diameters for cooking zones with the SIXTH SENSE function.

14 cm

FlexiCook

39 cm

18 cm

Max. Min.

INSTALLATION

After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.

PREPARING THE CABINET FOR FITTING

WARNING

min. 5 mm

min. 20 mm

min. 5 mm

• Install a separator panel under the hob.

• The lower part of the product must not be accessible

after installation.

• In case of installation of an undertop oven, do not

interpose the separator panel.

• Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could

damage them.

• The distance between the underside of the appliance and the separator panel must respect the dimensions given in the gure.

• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit.

• Do all cabinet cutting work before tting the hob, and carefully remove any shavings or sawdust.

• IMPORTANT: For installation in worktops made of marble or similar materials, do not use the screws provided, but contact the after-sales service and

request bonding kit 4812 310 19277.

After bonding the brackets in the position indicated, leave the silicone to dry for around 24 hours before proceeding with installation of the appliance.

ECO DESIGN DECLARATION

This appliance meets the eco design requirements of european regulation N. 66/2014, in conformity to the european standard EN 60350-2.