
79
INSTALLATION
Assembly
The hob can be installed into a frame between 30 mm and
50 mm deep and can be placed against a wall higher than the
worktop, leaving a minimum distance of 100 mm.
A.
If the worktop is made of wood use the supplied spring clips
and screws to assemble the hob.
•
Position the four clips (
A
) as shown and at the specified
dimensions.
•
Secure the clips using the 4 screws (
B
).
•
Insert the cooking hob in the worktop (see figure).
B.
If the worktop is made out of marble or other material
(plastic compounds, ceramics, stone etc.) fit the hob using
brackets suitable for this type of installation.
Install the hob in the worktop.
Position the four brackets (
C
) as shown in the figure, in
accordance with the thickness of the worktop.
Secure the 4 screws (
E
) in holes (
D
).
Very important reminders for cooling the electronic module.
To avoid overheating the electronic module, which could
decrease the effectiveness of the hob, it is advisable to assemble
the new induction hob following the instructions below.
If there is a drawer under the hob distance “
F
” must be at least
5 mm.
If an oven is to be installed (which must be of our manufacture
and have a cooling system) distance “
F
” must be 5 mm for HIGH
QUALITY ovens and 20 mm for others in the product range.
If the oven is positioned below the induction hob, do not use
the hob while the oven pyrolysis cleaning is running.
DECLARATION OF CONFORMITY
•
This cooktop is intended to come into contact with
foodstuffs and conforms to EEC Directive 89/109/EEC.
•
This appliance has been designed to be used only for
cooking. Any other use (e.g. for room heating) is to be
considered improper and consequently dangerous.
•
The appliance has been designed, constructed and sold in
compliance with:
- safety requirements of “Low voltage” Directive
73/23/EEC;
- protection requirements of “EMC” Directive 89/336/EEC;
- requirements of Directive 93/68/EEC.
#!").%4
/6%.
3gb53171b.fm5 Page 79 Wednesday, November 10, 2004 3:34 PM
Comentarios a estos manuales