Whirlpool AKT 8900 BA Instrucciones de uso descargar pdf (Pagina 6)

Connection to the terminal block

For the electrical connection, use an H05RR-F cable as specied in the table below.

Conductors Amount x size

220-240V ~ +

230-240V ~ +

380-425V 2N~ +

220-240V 3~ +

380-415V 3N~ +

3 x 4 mm

3 x 4 mm (Australia only)

4 x 1,5 mm

5 x 1,5 mm

4 x 1,5 mm

The appliance must be connected to the electricity supply by means of an omnipolar switch with minimum contact gap of 3mm.

IMPORTANT: the yellow/green earth wire must be connected to the terminal with the symbol and must be longer than the other wires.

• Check the connection diagram label under the hob and place/remove bridges according the connection type;

• Remove approx. 70 mm of the cable sheath from the power supply cable (B);

• Strip approx. 10 mm of sheath from the wires. Then insert the power supply cable into the cable clamp and connect the wires to the terminal block as

indicated in the connection diagram placed close to the terminal block itself;

• Secure the power supply cable (B) by means of the cable clamp;

• Close the terminal board with the cover (A) securing it with the screw provided;

• After the electrical connection, t the hob inside the cut-out.

CONTROL PANEL DESCRIPTION

Control panel

Timer controls

and display

Zone controls and display

On/Off

Melting

Boiling

Control

panel

lock

Dual/Triple

zone

First use / after a power failure

After connecting the hob to the electrical power supply, the control panel is locked. To unlock the control panel, touch the controls for 2 seconds. The control

panel lock indicator switches o and the hob can be used. Read the “Control panel lock” paragraph for more details.

Switching the hob ON/OFF

To switch the hob on, touch the control until the cooking zone displays light up. To switch o, touch the same control until the displays switch o. All the

cooking zones are deactivated. If within 30 seconds of switching on, no function is selected, the hob switches o automatically.

Switching on and adjusting cooking zones

Place the pot on the cooking zone, switching the hob on, activate the required cooking zone by touching the

corresponding “-” or “+” controls: “5” will appear on the display. With “-” and “+” controls it is possible to select the

required power level, from min. 0 to max. 9.

Deactivation of cooking zones

To switch o the cooking zone, touch simultaneously the control “-” and “+” or select the level “0” with the control “-”.

The cooking zone switches o and, if still hot, the letter “H” appears on the zone display.

Control panel lock

This function locks the controls to prevent accidental activation of the hob. To activate the control panel lock, touch the control ; an acoustic signal sounds

and a luminous indicator appears on the display. The control panel is locked except for the switching o function. To deactivate the control panel lock, repeat

the activation procedure.

The presence of water, liquid spilled from pots or any objects resting on the controls can accidentally activate or deactivate the control panel lock

Power indicator display

Selected cooking zone indication

(the dot blinks when there is a Timer active on that zone)