Whirlpool EKA 3483 IN RE Instrucciones de uso descargar pdf (Pagina 8)

INSTALLATION

Important information

This product has been designed, manufactured and

marketed according to the following:

- safety objectives of “Low Voltage” Directive 73/23/EEC;

- protection requirements of “EMC” Directive 89/336/EEC

amended by Directive 93/68/EEC.

The appliance has a type “Y” degree of protection against

fire;

it can therefore be placed against a wall higher than the

worktop.

DECLARATION OF CONFORMITY

The components of this appliance conform to EEC Directive

89/109; and can therefore come into contact with foodstuffs.

ELECTRICAL CONNECTION

To be done before connection to the electricity supply.

The appliance must be installed by a qualified electrician who is

fully aware of current safety and installation regulations.

Specifically, installation must be carried out in compliance with

the regulations of the local electricity supply company.

The

appliance must be connected to the electricity supply by

means of an all-pole disconnect switch with minimum

contact gap of 3 mm.

Make sure that the voltage indicated on

the rating plate corresponds to the voltage in your home.

Regulations require that the appliance is earthed: all conductors

(including the earth conductor) must be of the appropriate size.

The manufacturer declines all liability for injury to persons or

animals and for damage to property resulting from failure to

observe the above regulations.

INSTALLING THE HOB

Fit the hob into the housing, as indicated by the

manufacturer

Remove the drawer from the oven and push it into the

housing unit so that the earth wire and connectors of the

hob can be connected. For Oven-Hob connection, ensure

the colours of connectors match. Unscrew the nut of the

earth screw on the top cover of the oven and insert the

yellow/green earth wire, leaving the washer in place. Fully

tighten the nut back onto the screw.

Push the oven into the housing unit so that it is flush with the

front and secure it at the sides using the 4 screws (supplied).

Loosen the screws and remove the trim that secures the

terminal block at the bottom of the oven.

Connect the power supply cable (min 1.0 m long) to the

mains, as shown in the oven diagram.

Close the terminal block and trim again, screwing down

tightly.

Reposition the drawer.

Dual Zone

Keep warming

Front Right

Rear Right

Rear Left

Front Left

Earth

41966023aGB.fm Page 20 Friday, February 25, 2005 5:11 PM

1 2 3 4 5 6 7 8 9

Comentarios a estos manuales

Sin comentarios

Whirlpool EKA 3483 IN RE Instrucciones de uso Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool EKA 3483 IN RE