Whirlpool EKI 6640/IN Instrucciones de uso descargar pdf (Pagina 5)

Care and maintenance

Clean the hob after each use in order to avoid damaging

the surface and to prevent the formation of baked-on

deposits which are difficult to remove. Before cleaning,

make sure the cooking zones are switched off.

WARNING

• Steam cleaner is not to be used!

• Periodically check for dust under the

appliance, near the cooling air inlet or the

outlet openings. This could hinder the

ventilation and cooling of the electronic

module and decrease the effectiveness of

the hob.

To clean the hob, proceed as follows:

Use a soft clean cloth, absorbent kitchen wipes or a

proprietary cleaner for glass ceramic hobs. Do not use

abrasive sponges and/or metal scouring pads.

Food spills should be cleaned off before they bake

onto the glass ceramic surface. Sugar and foods with a

high sugar content damage the glass ceramic surface

and must be immediately removed using a scraper for

glass. Attention! Glass scrapers must be handled with

care.

Remove any stubborn food residues with a scraper or

proprietary detergents.

Salt, sugar and sand can scratch the glass ceramic hob:

Troubleshooting Guide

Before contacting After-sales Service:

•

Read and follow the instructions given in the section

“Operating instructions”.

•

Check that the electricity supply has not been shut off.

•

Clean the hob and dry it thoroughly.

•

Check that the knob is in the correct position: at

position “0” or the levels indicated by a continuous line,

the cooking zones do not receive any power.

•

If you use a pot that is not suitable for an induction

cooktop, the cooking zone it is placed on will switch off

after 1 minute. To resume operation, turn the knob to

“0”, place a pot that is suitable for the induction cooktop

(see section “Before use”) on the desired cooking zone

and turn the knob to the required level.

•

If the internal temperature of electronic parts is too

high, the hob will switch off automatically. Wait for the

hob to cool down before using it again. To resume

operation, turn the knob to “0” and then to the desired

power level

WARNING

If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately

from the power supply.

After-sales Service

Before contacting After-sales Service:

•

Try to solve the problem (see “Troubleshooting

Guide”).

•

Switch the appliance off, wait 30 seconds then switch it

on again to see if the fault persists.

If after the above checks the fault persists, contact the

nearest After-sales Service.

Always provide:

•

a brief description of the fault;

•

the exact type and model;

•

the service number (number after the word Service on

the dataplate), located under the hob or in the warranty

booklet;

•

your complete address and phone number.

If any repairs are required, please contact an authorized

After-sales Service as indicated in the warranty.

WARNING

Failure to comply with these instructions

may compromise the safety and quality of

the product.

MAINTENANCE

41901112GB.fm Page 14 Thursday, August 21, 2008 12:25 PM

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios

Whirlpool EKI 6640/IN Instrucciones de uso Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool EKI 6640/IN