Whirlpool Automatic Ice Maker Guía de instalación descargar pdf (Pagina 8)

Refer to the side diagram for the following

step. You will be working inside the freezer

compartment.

1. Install the plastic extension by sliding it over

the fill tube as far as it will go.

Refer back to the side diagram for the

following step.

2. Position the wiring harness so that it is

through the slot in the wiring cover. Insert

the tab at the back of the wiring cover into

the freezer liner slot. Press the pin on the

side of the wiring cover into the hole in the

side of the freezer liner so it locks into

place. Secure the wiring cover with the

phillips screw you removed earlier.

Proceed to “Installing the tubing clips” on

page 10.

Tab

Insert tab

into slot

Replacing the ice maker wiring cover

Installing the long fill tube extension

Fill tube

Long fill

tube extension

Wiring harness

Slot

Break off and discard

Wiring

cover

Wiring

harness

Hole

Slot

Phillips

screw

Insert pin

into hole

Hole cover

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

Whirlpool Automatic Ice Maker Guía de instalación Pagina 8