Whirlpool SI DC30 BA1 UK Instrucciones de uso

EN Operating Instructions

1010enno-steam and steam ironing mode. 1. Check that the water level in the reservoir is higher than ¼.2. Select the recommended ironing temperature

1111enand chapter “Using the iron”, section “Selecting the temperature and adjusting the steam”).3. Press the shot of steam button (1) to obtain an

1212enCleaning (J)Never use aggressive and/or abrasive substances to clean the plastic parts and the iron soleplate.1. Set the steam regulator (3) to

1313enimpurities. Never use plastic containers for collection.7. Switch off the iron and disconnect it from the electrical socket.8. Set the steam s

1414en• The plug may not be inserted into the electrical socket, or it may not make contact.• Check that the temperature is not set to MIN.• The te

1515en• The soleplate temperature may be too low due to the excessively frequent activation of the shot of steam button. Slightly increase the interv

Indesit Company UK LtdMorley Way,Peterborough PE2 9JBwww.indesitcompany.comQuick Perfection2015/03 ver. 2.1.

SI DC30 BA1 UKSI E40 BA1 UKLCD4a556699887711112311413124b4c23113121010

C1LCDC2C OTTONB1LCDALCDE1E2LCDD1 D2LCDB2

FLCDGLCDH1LCDH2LINENK1LCDK2ILCDJLCD

55enGENERAL SAFETY RULES• Do not operate the iron in case of damaged plug, power cord or appliance, or in the presence of visible damage or water lea

66en• For your safety, all repairs or maintenance operations must be carried out exclusively the the Hotpoint authorised technical staff.• Keep the

77enDESCRIPTION OF YOUR IRON1. Shot of steam button2. Spray button3. Steam regulator4a. Temperature buttons +/-4b. Temperature control4c. Temper

88enIfa13ampplug(BS1363)isused itmustbettedwith a 13 amp fuse, either in the plug or adaptor or at the distribution board. If you are in

99enBefore lling the iron with water, make sure thatthe iron is switched-off and disconnected from the electrical socket.1. Set the steam r