Whirlpool AWM 6101 Instrucciones de uso descargar pdf (Pagina 12)

Check whether:

• the siphon is correctly installed and clean

(see “Care and Maintenance”);

• enough water is being supplied. The mesh filters

between the inlet hose and the tap could be

blocked (see “Care and Maintenance”). Check

and clean the filter two or three times a year

(see “Removing the filter”).

The appliance vibrates during the spin

cycle.

Check whether:

• the appliance is levelled and solidly installed on

all four feet (see “Installation Instructions”);

• the transit bolts have been removed. The transit

bolts must be removed before the appliance can

be used (see “Installation Instructions”).

Final spin results are poor:

The appliance has an imbalance detection and

correction system. If individual heavy articles are

loaded (bathmat, bathrobe, etc.) this system may

reduce the spin speed automatically to protect the

appliance or even interrupt the spin cycle

altogether, if the imbalance is too great even after

several spin starts.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry to balance

the load and repeat the spin cycle.

• Excessive foam formation may prevent spinning.

Ensure correct amount of detergent is used

No water or insufficient water supply:

• the appliance has a safety hose and the safety

valve has opened (red indicator in the safety

valve inspector window).

In this case replace it with a new safety hose.

What should I do when the automatic safety system detects a malfunction?

The programme is interrupted and various indicators (if available) point to the source of the fault.

Fault description table

Small lamp lights up Digital display Fault description

“Water tap” “FH”“Water inlet fault”

- “FP”“Draining fault”

-from “F4” to “F15”“Electrical components fault”

“Water Stop”“FA”“Water Stop fault”

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Whirlpool AWM 6101 Instrucciones de uso Pagina 12