Whirlpool AWM 8000/1 Instrucciones de uso descargar pdf (Pagina 12)

What should I do when the automatic safety system detects a malfunction?

The programme is interrupted and various indicators (if available) point to the source of the fault.

Fault description table

a.Water inlet fault (no water or insufficient

water pressure)

The “Water tap closed” indicator is on and the

digital display shows “FH” Switch off the

appliance by turning the programme selector to

the “ ” position and unplug it.

Check whether:

•

the water tap is open and the water supply

pressure is sufficient;

•

the water inlet hose is kinked;

•

the mesh filter between the tap and the hose is

clean (see “Care and Maintenance” / “Mesh filter

in water connection”);

•

the water supply hose is frozen up.

Connect the appliance to the electrical supply.

Reselect the desired programme and press the

“Start/Pause”

button again to continue with

the programme (do not add detergent for this

programme)

b.Draining fault

The digital display shows “FP”. Switch off the

appliance by turning the programme selector to

the “ ” position and unplug it.

Check whether:

•

the drain hose is kinked (see “Installation”);

IMPORTANT

: before draining, allow the wash

water to cool down.

•

the drain hose is frozen.

Connect the appliance to the electrical supply.

•

The pump/filter is blocked (see “Removing the

Filter” / “Draining Residual Water”).

IMPORTANT:

Make sure that the washing

water has cooled before draining.

Reselect the desired programme and press the

“Start/Pause”

button again to continue with

the programme (do not add detergent for this

programme). If the fault re-occurs, contact After

Sales Service (See “After Sales Service”).

c.Electrical module fault

The digital display shows “F4” to “F21”.

•

Set the programme selector to the “ ”

position, select the desired programme and

press the

“Start/Pause”

button again. The

programme will continue.

•

If the fault re-occurs, contact After Sales

Service (See “After Sales Service”).

d.Water Stop fault

An audible tone sounds. The light of the Water

Stop indicator goes on. The digital display shows

“FA” and the pump is running.

The “Water Stop fault” may have been

triggered by:

•

too much foam.

•

a leak in the appliance, water running into the

water tank.

Switch off the appliance by turning the

programme selector to the “ ” position,

unplug the appliance and turn off the tap.

Inform After-Sales Service and describe the fault

(see “After-Sales Service”).

If the “Start/Pause” button has not been pressed

but water is still running into the machine, shut

the water intake and also inform After-Sales

Service (see “After-Sales Service”).

Small lamp lights up Digital display Fault description

“Water tap closed” “FH” “Water inlet fault”

- “FP” “Draining fault”

- from “F4” to “F21” “Electrical components fault”

“Water Stop” “FA” “Water Stop fault”

3gb15103.fm Page 15 Friday, August 27, 2004 6:52 PM

Black process 45.0° 150.0 LPI

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Comentarios a estos manuales

Sin comentarios

Whirlpool AWM 8000/1 Instrucciones de uso Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Lavadoras Whirlpool AWM 8000/1