26
a. Water inlet fault (no water or insufficient
water pressure)
The Water tap closed indicator is on and the
digital display shows FH Switch off the
appliance by turning the programme selector to
the position and unplug it.
Check whether:
the water tap is open and the water supply
pressure is sufficient;
the water inlet hose is kinked;
the mesh filter between the tap and the hose is
clean (see Care and Maintenance / Mesh filter
in water connection);
the water supply hose is frozen up.
Connect the appliance to the electrical supply.
Reselect the desired programme and press the
Start/Pause button again to continue with
the programme (do not add detergent for this
programme)
b.Draining fault
The digital display shows FP. Switch off the
appliance by turning the programme selector to
the position and unplug it.
Check whether:
the drain hose is kinked (see Installation);
IMPORTANT: before draining, allow the wash
water to cool down.
the drain hose is frozen.
Connect the appliance to the electrical supply.
Reselect the desired programme and press the
Start/Pause button again to continue with
the programme (do not add detergent for this
programme). If the fault re-occurs, contact After
Sales Service (See After Sales Service).
the pump or the foreign body trap (if fitted on
your appliance) is blocked. See Removing the
filter, in the previous chapter.
c. Electrical module fault
The digital display shows F4 to F21.
Set the programme selector to the
position, select the desired programme and
press the Start/Pause button again. The
programme will continue.
If the fault re-occurs, contact After Sales
Service (See After Sales Service).
d. Water Stop fault
An audible tone sounds. The light of the Water
Stop indicator goes on. The digital display
shows FA and the pump is running.
The Water Stop fault may have been triggered by:
too much foam.
a leak in the appliance, water running into the
water tank.
1.Switch off the appliance by turning the
programme selector to the position,
unplug the appliance and turn off the tap.
2.Tilt the appliance forwards carefully to allow the
collected water to flow out,
3.plug the washing machine in again and turn on
the tap,
4.reselect the desired programme and press the
Start/Pause button (there is no need to add
additional detergent). The programme will
continue. If the faults occurs again, call After-
Sales Service with details about the fault (see
After Sales Service),
5.If the Start/Pause button is not pressed but
water is still flowing into the machine, turn off
the water supply and inform After Sales Service
(see After Sales Service).
3gb15098.fm Page 26 Friday, November 14, 2003 4:48 PM
Black process 45.0° 100.0 LPI
(48 paginas)
(12 paginas)
(84 paginas)
(24 paginas)
(60 paginas)
(32 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales