Whirlpool 925 series Guía para resolver problemas descargar pdf (Pagina 11)

Removing the Pump Motor Assembly

1. Unscrew and remove the nozzle cap and remove

the nozzle bearing and spray arm.

(Fig. 2-7)

2. Disconnect the wiring harness from the motor

harness plug.

3. Rubber clamps secure the pump and motor

assembly to the tub. Rotate these inward 90°.

(Fig. 2-8)

4. Remove the drain hose and clamp from the

check valve and unscrew the check valve from the pump.

(Fig. 2-9)

5. Remove the tuned sound absorber. Use an open-end wrench to loosen the shaft from the

motor. Do not loosen the sound absorber by torquing on the large tuned resonator.

-- NOTE --

A small container will be required to catch water from the drain hose after removal.

Fig. 2-7

SPRAY ARM

NOZZLE

CAP

NOZZLE BEARING

6. Remove the pump and motor assembly by pulling up through the inside of the tub.

(Fig. 2-10)

Fig. 2-10

Fig. 2-8

Clamp

Shown Rotated

Inward 90°

Check Valve

Drain Hose

Clamp

Drain

Hose

Fig. 2-9

Tuned

Sound

Absorber

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Sin comentarios

Whirlpool 925 series Guía para resolver problemas Pagina 11