Whirlpool AKM281/IX Instrucciones de uso descargar pdf (Pagina 6)

INSTALLATION

Only for GERMANY, SWITZERLAND AND AUSTRIA

A) If the worktop is made out of wood

, use the springs provided.

Fit the four springs

(B)

into the relative seat under the box.

Make an opening in the worktop, according to the dimensions

indicated in the enclosed Product Description Sheet.

Install the cooktop in the worktop.

B) If the worktop is made out of marble or other

materials (plastics, ceramics or stone),

fix the hob by means

of brackets

(A)

(see figure on previous page), to be ordered

from the After Sales Service (code 4819 310 18528).

Electrical and mechanical connection

• The electrical connections must comply with local

regulations.

•

The data relevant to the voltage and power absorption are

indicated on the rating plate.

• The earthing of this appliance is compulsory by law.

• The manufacturer cannot be held responsible for any

injury to persons or animals or damage to property

arising from failure to comply with these requirements.

• When the cooktop is installed, provide a single-pole circuit

breaker with a contact separation of at least 3 mm.

Connection to gas supply

The gas supply system must comply with local regulations.

You can find specific local regulations for some countries, in the

separate National Safety Regulations Sheet supplied.

If no information concerning your Country is given, please ask

details to your Installer.

The connection of the cooktop to the gas pipe network or gas

cylinder must be made by means of a rigid copper or steel pipe

with fittings complying with local regulations, or by means of a

continuous-surface stainless steel hose complying with local

regulations. Interpose gasket

“B”

in the elbow connection

“A”

The maximum length of the hose is 2 m.

ONLY FOR BELGIUM:

It is necessary to replace the elbow connection (A) on the

appliance, with the one supplied.

Important: if a stainless steel hose is used, it must be installed

so as not to touch any mobile part of the furniture. It must

pass through an area where there are no obstructions and

where it is possible to inspect it on all its length.

After connection to the gas supply, check for leaks with

soapy water.

CONNECTION AND INSTALLATION

Oven - Cooktop with universal joints

After having installed and fixed the cooktop, install the oven. See

the oven instructions booklet.

Connect tongues

(A)

to end

(B)

as shown in the figure.

If the cooktop is equipped with an electric hotplate, connect

3-plug assembly

(R)

to the first 3 bores of the 5 pole

terminal board on block

(A)

as shown in the figure.

Position the oven and fix it with the screws supplied.

Fit the knobs, pressing them into their seats on the control panel.

Note: If the cooktop must be connected to a control box,

instead of the connection to the oven, please read

carefully the instructions supplied with the control box.

6gb61801b.fm5 Page 16 Friday, April 11, 2003 2:44 PM

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios

Whirlpool AKM281/IX Instrucciones de uso Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool AKM281/IX