Whirlpool AKT 970/IX Instrucciones de uso descargar pdf (Pagina 2)

BEFORE USING THE GLASS CERAMIC HOB

• To make the most of your new appliance,

please read the user instructions carefully and

keep them to hand for future consultation.

INSTALLATION

Hob

• The hob must be set into a worktop between 20 mm

and 50 mm deep

• For the distance between the underside of the glass

ceramic hob and the cupboard or separating panel,

observe the dimensions given in figure “A”.

• If the hob is to be installed next to a column unit, leave

a distance of at least 100 mm from the edge of the hob.

• Make an opening in the worktop of the dimensions shown in

the Product Description Sheet supplied separately.

• Apply the supplied gasket to the hob (unless it has already

been fitted), after having cleaned its surface.

Important

In order to prevent the electronic circuits from overheating, and

therefore from being damaged, we recommend the following:

• Do not install the hob near a dishwasher or washing

machine, so that the electronic circuits do not come

into contact with steam or moisture, which could

damage them.

If an oven (which must be of our manufacture) is to be installed

under the hob, ensure it is equipped with a cooling system and

observe the distances given in figure “B”.

There must be nothing between the hob and the oven (cross

rails, panels, brackets, etc.).

If the oven has a self-cleaning function (pyrolysis), do not use the

hob whilst this function is selected.

If the temperature of the electronic circuits exceeds the

maximum permitted temperature, the hob will switch off

automatically; in this case, wait for a few minutes until the

internal temperature of the electronic circuits reaches a tolerable

level, at which point it will be possible to switch the hob on again.

• Switch the hob off after use.

Rear wall

Front

31902060GB.fm Page 13 Friday, October 8, 2010 4:48 PM

1 2 3 4 5 6 7 8

Sin comentarios

Whirlpool AKT 970/IX Instrucciones de uso Pagina 2