Whirlpool AKT 970/IX Instrucciones de uso descargar pdf (Pagina 4)

ELECTRICAL CONNECTIONS

Electrical connection must be made before connecting the

appliance to the electricity supply. The appliance must be

installed by a qualified electrician who is fully aware of current

safety and installation regulations. Specifically, installation must be

carried out in compliance with the regulations of the local

electricity supply company. Make sure that the voltage indicated

on the rating plate corresponds to the voltage in your home.

Regulations require that the appliance be earthed: use

conductors (including the earth conductor) of the appropriate

size only. The manufacturer declines all liability for injury to

persons or animals and for damage to property resulting from

failure to observe the above regulations. For the electrical

connection use a H05RR-F type cable as indicated in the table

below:

Power supply voltage.

If the hob comes already supplied with a power supply

cable, see the diagram for connection to the mains

electricity supply. The appliance must be connected to the

electricity supply by means of an all-pole disconnect switch

with minimum contact gap of 3 mm.

Attention: the power supply cable must be long enough to allow

the hob to be removed from the worktop and must be

positioned so as to avoid damage or overheating caused by

contact with the base.

Connecting to the terminal board

N.B.: the yellow/green earth wire must be connected to the

terminal with the symbol and must be longer than the other

wires.

• Open the terminal board as shown on the cover (A)

• Remove approx. 70 mm of the cable sheath from the power

supply cable (B).

• Strip approx. 10 mm of sheath from the wires. Then insert the

power supply cable into the cable clamp and connect the

wires to the terminal block as indicated in the connection

diagram placed close to the terminal block itself.

• Secure the power supply cable (B) by means of the cable

clamp.

• Close the terminal board with the cover (A) securing it with

the screw provided.

• After the electrical connection, fit the hob from the top and

hook it to the support springs, following the diagram.

Each time the hob is connected to the mains

it carries out an automatic check which lasts several seconds.

Conductors Amount x size

230 V ~

3 X 2.5 mm

230-240 V ~ +

3 X 2.5 mm

(Australia only)

230 V 3~

4 X 1.5 mm

400 V 3N~ +

5 X 1.5 mm

400 V 2N~ +

4 X 1.5 mm

31902060GB.fm Page 15 Friday, October 8, 2010 4:48 PM

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Whirlpool AKT 970/IX Instrucciones de uso Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool AKT 970/IX