Whirlpool CLHB 30 NE Instrucciones de uso descargar pdf (Pagina 8)

GB6

Connection to the terminal block

For the electrical connection, use an H05RR-F cable as specified in the table below.

Important:

- Based on the wiring diagram (see figure) either keep or remove the metal jumpers between the screws on the

terminal block L1-L2 and N1-N2.

- Make sure all six screws on the terminal block are tightened after connecting the cables.

Example of jumper present (left) or removed (right). See the wiring diagram for details (the jumpers can be between L1-L2

and between N1-N2).

Connect the yellow/green earth wire to the terminal with the symbol .

This wire must be longer than the other wires.

1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).

2. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection

diagram located near it.

3. Secure the power cable with the cable clamp.

4. Close the cover (C) and screw it on the terminal block with the previously removed screw.

Each time the power is connected, the hob performs an automatic check for a few seconds.

If the hob already has a power cable, follow the instructions attached to the cable. Connect the appliance to the power

supply by means of a multipole switch with minimum contact gap of 3mm.

ELECTRICAL CONNECTION

WARNING

- Disconnect the appliance from the power supply.

- Installation must be carried out by qualified personnel who know the current

safety and installation regulations.

- The manufacturer declines all liability for injury to persons or animals and for

damage to property resulting from failure to observe the regulations provided

in this chapter.

- The power cable must be long enough to allow the hob to be removed from

the worktop.

- Make sure the voltage specified on the dataplate located on the bottom of the

appliance is the same as that of the home.

Wires Number x size

230 V ~ +

3 x 4 mm

230-240 V ~ +

3 X 4 mm

(Australia only)

230 V 3 ~ +

4 x 1.5 mm

400 V 3N ~ +

5 x 1.5 mm

400 V 2N ~ +

4 x 1.5 mm

400 V 3N ~ 230 V ~

230-240 V ~ (Australia only)

230 V ~ (UK only)

400 V 2N ~ 230 V 3 ~ (Belgium only) 400 V 2N ~ (Holland only)

230 V

CBA

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Whirlpool CLHB 30 NE Instrucciones de uso Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool CLHB 30 NE