Whirlpool KP9I96(X)/DE Instrucciones de uso descargar pdf (Pagina 34)

Installation

! Before operating your new appliance please read

this instruction booklet carefully. It contains important

information concerning the safe operation, installation

and maintenance of the appliance.

! Please keep these operating instructions for future

reference. Pass them on to possible new owners of the

appliance.

The following instructions are provided for qualified

installers so that they may accomplish installation,

adjustment and technical maintenance operations

correctly and in compliance with current regulations

and standards.

Important: the appliance should be disconnected

from the mains electricity supply before any

adjustment, maintenance, etc. is carried out.

Maximum caution should be used should it be

necessary to keep the appliance connected to the

electricity supply.

The appliance has the following technical

specifications:

Class: 1

Positioning

The dimensions of the appliance are given in the

figure. For trouble-free operation of appliances

installed in housing units, the minimum distances

shown in figure should be observed. Adjacent

surfaces and the wall at the rear should also be able

to withstand an overheating temperature of 65 °C. On

the lower part of the stove there are 4 adjustable feet

with a screw which will allow you to level the stove

when necessary. It is essential for the appliance to be

level. Warping caused by bad positioning could alter

the characteristics and performance of the appliance

itself.

Electrical connection

THE APPLIANCE MUST BE EARTHED

The hob is designed to work with alternating current at

the supply voltage and frequency indicated on the

data plate (situated on the bottom part of the

appliance or on the last page of the instruction

booklet). Make sure that the local supply voltage

corresponds to the voltage indicated on the data

plate. The hob is not fitted with a power supply cable,

as the cable should be sized according to the type of

electrical connection in use (see connection diagram

below). Use a H05VV-F rubber cable.

Open the terminal board following the instructions on

the diagram opposite:

To install the power supply cable, proceed as follows:

• Unscrew the wire clamp screw “V” and the contact

screws.

• Fasten the small cables beneath the screw heads

according to the diagram below.

• Fasten the supply cable in place with the clamp

and close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate. When connecting the

cable directly to the mains, install an omnipolar switch

with a minimum contact opening of 3 mm between the

appliance and the mains. The omnipolar switch should

be sized according to the load and should comply

with current regulations (the earth wire should not be

interrupted by the switch). The supply cable must be

in such a position that no part of it can reach a

temperature of 50°C above room temperature. Before

connecting to the power supply, make sure that:

• The limiter valve and the domestic system can

withstand the load from the appliance (see data

plate);

• The mains are properly earthed in compliance with

current directives and regulations;

• There is easy access to the socket and omnipolar

switch, once the hob has been installed.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

Comentarios a estos manuales

Sin comentarios

Whirlpool KP9I96(X)/DE Instrucciones de uso Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool KP9I96(X)/DE