
16
GB
supporting surface.
The screws for the alignment springs must remain
accessible.
In order to adhere to safety standards, the appliance
must not come into contact with electrical parts once it
has been installed.
All parts that ensure the safe operation of the appliance
must not be removable
without the aid of a tool.
Electrical connection
The electrical connections of the hob and any built-in
oven must be carried out separately, both for safety
purposes and to make extracting the oven easier.
5 mm
min. 20 mm
min. 20 mm
min. 40 mm
COMPARTMENT
5 mm
min. 40 mm
FAN-ASSISTED
OVEN
FRONT SIDE
OF HOB
SUPPORTING
SURFACE
30
40
UNDERSIDE
OF HOB
Ventilation
To allow adequate ventilation and to avoid overheating
of the surrounding surfaces the hob should be positioned
as follows:
At a minimum of 40 mm from the back panel.
So that a distance of at least 20 mm is maintained
between the installation cavity and the cabinet
underneath.
Fixing
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could affect
the features and operation of the hob.
The thickness of the supporting surface should be taken
into account when choosing screws for the fixing hooks:
30 mm thick: 23 mm screws.
40 mm thick: 13 mm screws.
Fix the hob as follows:
1. Use short, flat-bottomed screws to fix the 4 alignment
springs in the holes provided at the central point of each
side of the hob.
2. Place the hob in the cavity, make sure it is in
a central
position and push down on the whole perimeter until the
hob is stuck to the supporting surface.
3. For hobs with raised sides: After inserting the hob into
its cavity, insert the 4 fixing hooks (each has its own pin)
into the lower edges of the hob, using
the long pointed
screws to fix them in place, until the glass is stuck to the
Comentarios a estos manuales