Whirlpool K1G11S(W)/I Instrucciones de uso descargar pdf (Pagina 16)

Tight control

Important:Important:

Important: when installation has been completed,

check the pipe fitting for leaks with a soapy solution.

Never use a flame. Once the connection has been

made, ensure that the flexible metal tube does not

touch any moving parts and is not crushed.

Connecting the supply cable to the mains

Install a normalised plug corresponding to the load

indicated on the data plate. When connecting the

cable directly to the mains, install an omnipolar

circuit-breaker with a minimum contact opening of 3

mm between the appliance and the mains. The

omnipolar circuit breaker should be sized according

to the load and should comply with current

regulations (the earth wire should not be interrupted

by the circuit breaker).

The supply cable should be positioned so that it

does not reach a temperature of more than 50°C with

respect to the room temperature, along its length.

Before making the connection, check that:

• the limiter valve and the home system can

support the appliance load (see data plate);

• the mains is properly earthed in compliance with

current directives and regulations;

• there is easy access to the socket and omnipolar

circuit breaker, once the hob has been installed.

N.B:N.B:

N.B: never use reducers, adaptors or shunts since

they can cause heating or burning.

The plug and socket must be easilyThe plug and socket must be easily

The plug and socket must be easily

accessible.accessible.

accessible.

Adapting the cooker to different types of gas

In order to adapt the cooker to a different type of

gas with respect to the gas for which it was

produced (indicated on the label attached to the lid),

follow these steps:

a)a)

a)replace the hose holder mounted on the appliance

with that supplied in the bag of “cooker

accessories”.

Important: Important:

Important: the hose holder for liquid gas is marked

8, the hose holder for methane gas is marked 13.

Always fit the sealing gasket.

b)b)

b )Replacing the burner nozzles on the hob:

• remove the grids and slide the burners from their

housings;

• unscrew the nozzles using a 7 mm socket

spanner, and replace them with nozzles for the

new type of gas (see table 1

“Burner and nozzle

characteristics”).

• replace all the components

by repeating the steps in

reverse order.

c)c)

c) Minimum regulation of the

hob burners:

• turn the tap to minimum;

• remove the knob and adjust the regulation screw,

which is positioned in or next to the tap pin, until

the flame is small but steady.

N.B.:N.B.:

N.B.: in the case of liquid gas, the regulation screw

must be screwed in to the bottom.

• check that the flame does not turn off when you

turn the tap quickly from high to low.

d Regulating the primary air of the burners:

The primary air of the burners requires no

regulation.

Important:Important:

Important: On completion of the operation, replace

the old rating sticker with one indicating the new

type of gas used. This sticker is available from our

Service Centres.

NoteNote

Note: Should the pressure of the gas used be

different (or vary) from the recommended pressure,

it is necessary to fit a suitable pressure regulator

onto the inlet pipe in compliance with current

National Regulations relative to “regulators for

channelled gas”.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comentarios a estos manuales

Sin comentarios

Whirlpool K1G11S(W)/I Instrucciones de uso Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Hornos Whirlpool K1G11S(W)/I