INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND
CAREFULLY. THEY WILL SIMPLIFY THE INSTALLATION.
1.
After removing the shipping carton, be sure to
remove all protective packaging materials such as
tape and shipping pads. Waxy residue from pro-
tective shipping material may be removed from
compactor with a mild solution of liquid household
cleaner and water.
2.
Your compactor IS deslgned for recessed lnstallatlon
A SIX (6) Inch clearance from the right edge of the
drawer front IS desirable for added convenience In bag
removal Also allow twenty-three (231 Inches In front
of the appliance for drawer removal See Figure 3.
WALL OR
O.iHER
OBJECTS
3. The compactor’s overall dlmenslons are’ Helaht 34.
l/16”
(mln
). Depth 24”. Width 15” Select a cabinet
opening to fit. See Figure 4
f
34-l/16”
I
8
41
-1 -,f24”
-Is+
FIGURE 4
4. Remove drawer as shown,
a Grip handle and raise front of drawer until It
clears stops See Figure 5
b. Grasp side ridges of the drawer and lift drawer
out See Figure 6
?1
t ’
I:
FIGURE 5
-FIGURE 6
5.
Remove any materials that are shipped In the drawer,
Some models have a I:terature storage compartment
located InsIde the front panel See Figure 7. DO NOT
REMOVE THE BAG.
LITERATURE
STORAGE
FIGURE 7
6.
Lay two carton corner posts or other protective
material (such as a throw rug) on the floor, then lay
the unit on either of its sides on the corner posts. The
corner posts
will
protect the finish of the compactor
and the floor See Figure 8 NOTE: Do no1 :ruck or
handle by console
7.
8.
9.
FIGURE 8
Remove the cardboard shlpplng pad located on the
bottom See Flgure 8 Stand compactor upright
A grounded receptacle should be located 18” (min.)
from the floor and In the center of the opening. See
Figure 9
r
FIGURE 9
Before moving the compactor Into position, measure
the cabinet opening as shown In Figure 10. To
determine If height adjustment
IS
required. see steps
9 and 10 below
-CABINET OPENING
0 I &
m
cl
FIGURE
10
The rear wheels of your compactor are preset for a
mInImum cabinet opening of 34-l 18” to 34-l 14”
(posItIon A) To adjust for higher openings, tilt the
compactor to one side and support with a corner post
or a screwdriver handle
CAUTION: Use care so that the compactor does
not drop on your hand.
10.
To adjust the height, remove screw from posltion “A”
In Figure 11. Move the rear wheel and screw to
position “B or C”
34-l 14” to 34-l ‘2” use posltion “B”
34-l 12” to 34.3/4” use posltlon “C”
A
Be
*
co
FIGURE I1
Repeat for other rear wheel
780291 Rev. A
(16 paginas)
(24 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales