Whirlpool ACM 704/NE Instrucciones de uso descargar pdf (Pagina 2)

The appliance must be installed by a qualified technician

who is fully aware of current safety and installation

regulations. The manufacturer declines all liability for injury

to persons or animals and for damage to property resulting

from failure to observe the regulations provided in this

chapter.

Electrical connections

Important!

• Electrical connection must be made before connecting

the oven to the electricity supply.

• The appliance must be earthed.

• For electrical connection, refer exclusively to the

instructions given in the following paragraph, ignoring

the connections indicated on the underside of the hob.

Connecting the cable to the terminal

block

1. Remove the terminal block screws and the jumpers.

2. Connect the wires to the terminal block as shown in

the wiring diagram below.

3. Secure the cable with the cable clamp next to the

protective black sheath.

4. Remove the terminal block cover (A), undoing the

screw and inserting the cover in the terminal block

hinge (B). Close the cover (C) and screw it on the

terminal block.

Connection to the oven

WARNING

Do not connect the oven to the power

supply before you have finished connecting

the cooktop.

• Before connecting the oven to the power supply, make

sure that the cooktop is among the ones listed in the

cooktop/oven pairing product sheet provided.

• Connect the hob connectors (E) to the oven connectors

(D), matching the colours and the alignment of the

housing guides visible on the top of the connectors.

• Then make the connection by pushing the connectors all

the way in, making sure that the tongue clicks into place.

• Unscrew the nut of the earth screw (K) on the top

cover of the oven and insert the yellow/green earth

wire, leaving the washer in place. Screw the nut back

onto the screw and tighten it as far as it will go.

• Group the previously connected cables together and

cover them with the metal cover (F), taking care that the

cables are not trapped under the cover.

• Tighten the two screws (G) to secure the metal cover

provided with the oven.

INSTALLATION AND ELECTRICAL CONNECTION

Legend:

- R = brown

- S = brown

- E = yellow/green

- N = blue

1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios

Whirlpool ACM 704/NE Instrucciones de uso Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool ACM 704/NE