Whirlpool ACM 829/AL Instrucciones de uso descargar pdf (Pagina 12)

EN 12

The Flexi cook function is also able to detect when a pot is moved from one zone to the other one within the exi cook area keeping the same power level of

the zone where the pan originally was placed (see the example in the gure below: if the pot is moved from the front heater to the rear heater, the power level

will be shown on the display corresponding to the zone where the pot is placed).

It is also possible to operate the Flexi cook area as two independent cooking zones, using the corresponding button of the single zone. Place the pot in the

center of the single zone and adjust the power level with the slide touchscreen.

Important: make sure to place the pans centered on the cooking zone in the way to cover the center of the single cooking zone.

In case of big pot, oval, rectangular and elongated pans make sure to place the pans centered on the cooking zone.

Examples of good pot placement and bad pot placement:

CLEANING

WARNING

• Do not use steam cleaners.

• Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”) is not

displayed.

If your glass has the iXelium

logo, your hob is equipped with iXelium

treatment. iXelium

is the exclusive Whirlpool nishing that guarantees a perfect

clean and a long-lasting brilliance. Therefore, if you have a IXELIUM hob, we strongly suggest to observe the following cleaning recommendations:

• Use a soft cloth (microbre is best) dampened with water or with everyday glass cleaning detergent.

• If you want to enhance furtherly cleaning results, just let the glass in contact with a wet cloth for couple of minutes.

IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.

• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.

• Sugar or foods with a high sugar content damage the hob and must be immediately removed.

• Salt, sugar and sand could scratch the glass surface.

• Use a soft cloth, absorbent kitchen paper or a specic hob cleaner (follow the Manufacturer’s instructions).

• Liquid splillages on the cooking zones may make pan vibrate or move.

• Dry the hob thoroughly after cleaning it.

TROUBLESHOOTING GUIDE

• Read and follow the instructions given in the section “Instructions for use”.

• Check that the electricity supply has not been shut off.

• Dry the hob thoroughly after cleaning it.

• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.

• If the hob cannot be switched off after using it, disconnect it from the power supply.

ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION

C81, C82

The control panel switches off

because of excessively high

temperatures.

The internal temperature of

electronic parts is too high.

Wait for the hob to cool down before

using it again.

F42 or F43 The connection voltage is wrong.

The sensor detects a discrepancy

between the appliance voltage and

that of the mains supply

Disconnect the hob from the mains

and check the electrical connection.

F12, F21, F25, F36, F37, F40, F47,

F56, F58, F60

Call the After-Sales Service and specify the error code

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 87 88

Comentarios a estos manuales

Sin comentarios

Whirlpool ACM 829/AL Instrucciones de uso Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool ACM 829/AL