Whirlpool AKM 476 Instrucciones de uso descargar pdf (Pagina 8)

INSTALLATION

Replacing the injectors (see table in enclosed product

description sheet)

Remove grids 

.

Extract burners 

.

Using a socket spanner of the appropriate size, 

,

unscrew the injector to be replaced.

Replace it with the injector suitable for the new type of gas.

Re-assemble the injector in 

.

For models equipped with a triple crown burner, proceed as

shown in figure.



Remove the two screws 

 followed by the cap 

 then

replace both injectors 

 as previously described.

Replace the cap 

, ensuring the seal is properly

positioned before attempting to use the cooktop.

Before installing the cooktop, remember to affix the gas

calibration plate supplied with the injectors in such a way that

it covers the existing information relating to gas calibration.

Adjusting minimum gas setting of taps

To ensure that the minimum setting is correctly adjusted,

remove knob 

 and proceed as follows:



tighten (-) to reduce the height of the flame;



loosen (+) to increase the height of the flame.

The adjustment must be performed with the tap in minimum gas

setting position (small flame) .

3gb66034.fm Page 19 Wednesday, May 28, 2003 5:50 PM

1 2 3 4 5 6 7 8 9

Sin comentarios

Whirlpool AKM 476 Instrucciones de uso Pagina 8