Whirlpool AKM 489 Guía para resolver problemas descargar pdf (Pagina 11)

FITTING THE WOK BURNER

REGULATING THE MINIMUM FLOW LEVEL

OF THE GAS TAPS

To fit the double crown wok burner:

Insert in the following order:

1. burner ring (A);

2. decorative covering ring (B);

3. external burner cap (C);

4. internal burner cap (D).

Note: make sure that:

1. the locating pin for the burner ring (A) is inserted correctly in

the slot on the burner unit.

2. that the locating pin on the

external burner cap (C) is

inserted in the slot on the

burner ring (A).

Regulating the minimum flow level must be done with the tap at

the lowest position (small flame) .

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the

control knob and adjust the screws found on the tap as follows:

1. tighten to reduce the height of the flame 1 (-)

2. slacken to increase the height of the flame (+);

3. With the burners on, rotate the buttons from the

maximum to the minimum position to check the stability

of the flame.

Once you have finished regulating, close up the seals again using

sealing wax.

1 2 ... 6 7 8 9 10 11 12 13

Sin comentarios

Whirlpool AKM 489 Guía para resolver problemas Pagina 11