Whirlpool AKM 489 Guía para resolver problemas descargar pdf (Pagina 9)

FIXING THE HOB TO THE WORK TOP.

FLUSH FITTED MODEL

Important: The following procedure must be

carried out by competent technical personnel

only. The hob can be installed on, or into

different types of materials, such as masonry,

metal, wood and heat resistant laminate

coated wood (90°C).

Cut an opening in the worktop to the dimensions

shown in the diagram.

Note: For laminated worktops with a laminate thickness of less

than 3 mm, create a recess as shown as on the detailed schematic

drawing.

Before positioning the hob, apply the adhesive gasket/seal

supplied, on the underneath edge of the hob itself, where the hob

will be in contact with the worktop (fig. 2).

Once the seal is in place, place the hob into the recess. Secure the

hob into the work surface using the screws and brackets

provided, tightening them until the hob is perfectly flush (fig. 3).

Carefully trim off the excess gasket/seal. In case of installation on

wood (particularly chipboard), any small spaces between the

edge of the worktop and the hob should be filled with small

quantities of silicon sealant (see fig. 4). Once the appliance has

been installed, the bottom of the hob should be completely

accessible.

Important:

• tighten the fixing brackets of the hob to the work top by hand,

using minimum force.

• In case of wooden (or similar) worktops, before fitting the

adhesive seal protect the surface of the milled recess with a

primer.

Slots for extra brackets have been created on the bottom of the

appliance, to help achieve a more flush positioning (should this be

necessary). Appropriate brackets can be obtained from the

Customer Care Centre.

860

848

115

R.11

861

? 2,2

Fig. 1

Fig. 2

Fig. 3

Fig. 4

1 2 3 4 5 6 7 8 9 10 11 12 13

Comentarios a estos manuales

Sin comentarios

Whirlpool AKM 489 Guía para resolver problemas Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool AKM 489