Whirlpool AKM 489 Guía para resolver problemas descargar pdf (Pagina 7)

INSTALLATION (FLUSH AND TRADITIONAL

FITTING)

Technical information for the installer

• This appliance can be installed into a 20 mm -

50 mm thick worktop.

• If no oven is to be installed below the hob, a panel

must be fitted under the hob to prevent hob

damage and protect the cupboard contents. This

panel must cover the whole of the underside of the

hob and must be positioned so that an air gap of at

least 50 mm between the panel and hob underside

is maintained, as a minimum, and as a maximum

150 mm to the underneath of the work surface.

• This hob is designed to operate perfectly with

any oven in the Whirlpool range. The

Manufacturer declines all responsibility

should another make of oven be installed.

Before installation, please ensure that:

• The gas supply (type and pressure) and the

calibration on the hob are compatible (see serial

number plate on the hob and the injector table).

• The cabinetry and appliances surrounding/next

to the hob are heat resistant and in compliance

with local regulations.

• The products of combustion are removed from

the atmosphere in the room by using an

extraction hood or electrical fan installed to the

walls and or windows, in line with current

regulations.

• The air circulates naturally through a suitable

opening that is no less than 100 cm

in cross

section, which must be:

- permanent and accessible on the walls of the

room being ventilated and extracting towards

the outside.

- created in such a way that the openings both

inside and out cannot be obstructed, even by

accident.

- Protected by plastic grill, and metallic netting

etc. that should not reduce the 100 cm

cross

section.

- Located in such a position so as not to interfere

with the extraction of the products of

combustion.

GAS CONNECTION

Connection to the mains gas system must be carried out

by a competent, registered person, in compliance with

current legislation.

• The connection of the hob to the gas mains network or gas

cylinder must be done using a rigid copper or steel pipe with

parts that comply with local standards, or using a flexible

stainless steel pipe with continuous surfaces that comply with

local standards. The flexible metallic pipe should be no longer

than 2 linear metres.

• Before connecting the pipe with the rubber part (A), insert

the seal (B) is in place (this part, provided complies with

EN 549).

Warning: if you use a stainless steel flexible pipe, it must be

installed in such a way that it does not come into contact with

moving cabinetry like drawers or kitchen cupboards and passes

at a point free of obstacles where it can be examined in its

entirety.

• After connecting to the gas mains, use soap and water to

check there are no leaks.

1 2 3 4 5 6 7 8 9 10 11 12 13

Comentarios a estos manuales

Sin comentarios

Whirlpool AKM 489 Guía para resolver problemas Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool AKM 489