Whirlpool KN3G10SA(W)/U Instrucciones de uso descargar pdf (Pagina 7)

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring

showing the strength of the flame for the relevant

burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired

level by turning the BURNER knob in an

anticlockwise direction. This may be the minimum

setting C, the maximum setting E or any position in

between the two.

If the appliance is fitted

with an electronic lighting

device* (

see figure

), press

the ignition button, marked

with the symbol

, then

hold the BURNER knob

down and turn it in an

anticlockwise direction,

towards the maximum flame setting, until the burner

is lit. The burner may be extinguished when the

knob is released. If this occurs, repeat the operation,

holding the knob down for a longer period of time.

! If the flame is accidentally extinguished, switch off

the burner and wait for at least 1 minute before

attempting to relight it.

If the appliance is equipped with a flame failure

safety device*(X), press and hold the BURNER knob

for approximately 2-3 seconds to keep the flame

alight and to activate the device.

To switch the burner off, turn the knob until it

reaches the stop position •.

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas

consumed, it is recommended that only pans that

have a lid and a flat base are used. They should

also be suited to the size of the burner.

Start-up and use

To identify the type of burner, please refer to the

diagrams contained in the “Burner and nozzle

specifications”.

Using the oven

! The first time you use your appliance, heat the

empty oven with its door closed at its maximum

temperature for at least half an hour. Ensure that the

room is well ventilated before switching the oven off

and opening the oven door. The appliance may emit

a slightly unpleasant odour caused by protective

substances used during the manufacturing process

burning away.

! Before operating the product, remove all plastic

film from the sides of the appliance.

1. Select the desired cooking mode by turning the

SELECTOR knob.

2. Select the recommended temperature for the

cooking mode or the desired temperature by turning

the THERMOSTAT knob.

A list detailing cooking modes and suggested

cooking temperatures can be found in the relevant

table (

see Oven cooking advice table

During cooking it is always possible to:

• Change the cooking mode by turning the

SELECTOR knob.

• Change the temperature by turning the

THERMOSTAT knob.

• Set the total cooking time and the cooking end

time (

see below

• Stop cooking by turning the SELECTOR knob to

the “0” position.

! Never put objects directly on the bottom of the

oven; this will avoid the enamel coating being

damaged.

! Always place cookware on the rack(s) provided.

Burner ø Cookware diameter (cm)

Fast (R) 24 - 26

Semi Fast (S) 16 - 20

Auxiliary (A) 10 - 14

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Comentarios a estos manuales

Sin comentarios

Whirlpool KN3G10SA(W)/U Instrucciones de uso Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool KN3G10SA(W)/U