
N C
M Y
INSTALLATION
GENERAL INFORMATION
1. The appliance is built in compliance with applicable
safety regulations and national/international EU
directives.
2. The appliance must be installed by a licensed
electrician in compliance with the laws in force in
your country and in observation of the instructions
supplied by the manufacturer
3. Remove all packing material from around and inside
the appliance.
4. Secure the four feet in the holes on the base o f the
appliance and adjust the height.
ELECTRICAL CONNECTION
Before making the connection:
x
check that the mains voltage coincides with the
voltage shown on the appliance data plate. The
rating plate can be seen at the bottom right of the
cooker, o n opening the oven door.
x
ensure that the electrical system in the place of
installation is equipped with an efficient earth
connection in compliance with the law.
Important
x
Fit an all-pole ON-OFF switch between the appliance
and the power supply with minimum contact
distance of 3 mm (power switch, overload cut-out
or relay).
The
marking confirms that the appliance conforms
to the f ollowing EU directives:
x
90/683; 73/23 (low voltage directive) and
amendments;
x
89/336 (electromagnetic compatibility) and
amendments.
The connection of the appliance to the
grounding unit is mandatory.
The manufacturer declines every
responsibility for any inconvenience
resulting from the inobservance of this
condition.
LOCATION
The cooker has type “Y” overheating protection so that
it can be installed in a cabinet.
The kitchen furniture near the sides of t he cooker
should be made of heat-resistant material.
49
49
Comentarios a estos manuales