Whirlpool TGE 4406-1SW Instrucciones de uso descargar pdf (Pagina 5)

N C

M Y

INSTALLATION

Technical information for the installer

This cooktop can be fitted into a working

surface from 20 to 55 mm thick.

Insert a separator panel so that there is a

minimum distance of 145 mm from the upper

part of the working surface to the upper part

of the separator.

Note: Before installation make sure that the

local distribution conditions (gas type and

pressure) and the cooktop adjustments are

compatible (see rating plate).

x

Any column unit must be at least 100 mm

away from the edge of the cooktop.

x

Before installing the cooktop, remove any

protective film. The coatings of the walls of

the unit or appliances next to the cooktop

must be heat resistant (protection against

heat “Y” according to standards EN 60335-2-6).

x

The installation must conform to the local

standards in force.

x

In the room where the cooktop is installed

there must be enough air for correct gas

combustion (see injector tables on the

Product Card).

x

The natural flow of air must occur through

a suitable opening which must be:

- Permanent and made in the outside walls

of the room to be ventilated, in an area

away from sources of pollution.

- Made so that the opening outlets, both

inside and outside the wall, cannot be

blocked, even accidentally.

- Protected with grids, metal net, etc. so as

not to reduce the useful section indicated

above.

- Situated at roughly floor level and such as

not to cause disturbance to the correct

operation of the combustion product

removal devices.

Assembly

x

Apply the supplied gasket to the cooking

hob (unless i t has already been fitted), after

having cleaned its surface as shown in the

relevant figure.

To fasten the cooking hob, use brackets

supplied with it.

1. Fit the brackets into the relevant bores and fasten

them by means of their screws.

2. Make an opening in the worktop, respecting the

dimensions A or B indicated in the enclosed

product description sheet. If the opening made is

of size

remove the two spacers from the

back part of the bottom of the surface.

C

3. Install the cooking hob in the worktop.

14

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios