Whirlpool ACM 394 D Instrucciones de uso Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
N C
M Y
USING THE ELECTRONIC PROGRAMMER
ACM 398 ACM 377
AUTOMATIC OVEN COOKING
To cook food automatically in the oven:
1. Set the length of the cooking time
2. Settheendofthecookingtime
3. Set the temperature and the oven cooking
programme.
These operations are done in the following way:
1. Set the length of the cooking time by pushing the
button and the
+
button to advance, or
to go
back if you have passed the desired time (fig. 10.5).
The AUTO and the
symbol will be on.
2. Settheendofthecookingtimebypressingthe
button (the cooking time already added to the clock
time will appear), and the
+
button (fig. 10.6); if
you pass the desired time you may go back by
pushing the
button.
After this setting, the
symbol will go off. If after
this setting, the AUTO flashes on the panel and a
buzzer gives off, it means there was an error in the
programming, that is that the cooking cycle has
been superimposed on the clock. In this case,
modify the end of cooking time or the cooking time
itself by following the above-mentioned instructions
again.
3. Set the temperature and the cooking programme by
using the oven switch and thermostat knobs (see
specific chapters).
Now the oven is programmed and everything will work
automatically, that is the oven will turn on at the right
time to end the cooking at the hourset. During cooking,
the
symbol remains on.
Push the
button to see the time that remains until
the end of cooking.
(10.7)
(10.8)
The cooking program may be cancelled at any
time by pushing
.
At the end of the cooking time the oven will turn off
automatically, the
symbol will turn off, AUTO will
flash and a buzzer will sound, which can be turned off
by pushing any of the buttons.
Turn the switch and thermostat knobs to zero and put
the programmer to “manual” by pressing the
button.
Attention: A power cut makes the clock go to zero
and cancels the set programmes. After a power cut,
three zeros will flash on the panel.
149
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Comentarios a estos manuales

Sin comentarios