Whirlpool AMD 383 Instrucciones de uso descargar pdf (Pagina 22)

THERE ARE 2 STYLES OF INSTALLATION

• CEILING TYPE

• FLOOR TYPE

Each type is similar to the other as follows; determine the

mounting position on ceiling or wall by using paper

pattern to indicate indoor frame. Mark the pattern and

pull out the paper pattern. Remove the return grill, the

side panel and the hanger bracket from the indoor unit as

per procedure below.

• Press the fixing knob of the return grilles, the grilles

will be opened wider and then pull it out from the

indoor.

• Remove the side panel fixing screw and pull to the

front direction (arrow direction) to remove (Refer to

Fig.24).

• Loosen two hanger bracket setting bolts (M8) on each

side for less than 10mm. Remove two hanger bracket

fixing bolts (M6) on the rear side. Detach the hanger

bracket by pulling it backward (Refer to Fig.26).

Set the suspension bolt.(Use W3/8 or M10 size

suspension bolts).

• Adjust the distance from the unit to the ceiling slab

beforehand (Refer to Fig.25). Fix the hanger bracket to

the suspension bolt.

WARNING

• Make sure that extended suspension bolt from the

ceiling stays inside the arrowed position. Readjust the

hanger bracket when it is outside the arrowed position

(Refer to fig. 27).

• Suspension bolt stays inside the cap of indoor unit.

Never remove the cap.

Lift the unit and slide forward unit the dent. (Refer to

fig. 28).

Screw tightly both hanger bracket settings bolts (M8)

(refer to fig. 26).

Screw tightly both hanger bracket fixing bolts (M6) to

prevent the movement of the indoor unit. (refer to

fig. 26).

Adjust the unit height so that rear side of the drain pipe

slightly inclines to improve drainage.

CAUTION

• Adjust the height by turning the nut with a spanner.

Insert the spanner from the hanger bracket opening

(refer to fig. 29).

In case of hanging

It is possible to install using inward facing hanger brackets

by not removing the brackets from indoor unit (refer to

fig. 30). Be sure to use only the specified accessories and

parts for installation work.

Side panel fixing screws (M4)

Fig. 24

Fig. 25

Ceiling

40 mm

or less

Suspension bolt

Hanger bracket

Fig. 26

Hanger bracket

Hanger bracket setting

bolt (M8)

Hanger bracket fixing

bolt (M6)

Ceiling slab

Bolt position

inward

Hanger bracket

Fig. 27

Fig. 28

Fig. 29

Fig. 30

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comentarios a estos manuales

Sin comentarios

Whirlpool AMD 383 Instrucciones de uso Pagina 22

Comentarios a estos manuales