Whirlpool AMD 385 Instrucciones de uso descargar pdf (Pagina 30)

Form 1: The tightening torque needed for tightening nut

• Examine the connection pipe to see if it had gas leakage, then take the treatment of heat insulation, as

shown in the fig.3.

• Only use median sponge to entwine the wiring interface of the gas pipe and heat preservation sheath of

the gas collection tube.

G. Drainage hose

1. Install the drain hose

• The diameter of the drain hose should be equal or bigger than the connection pipe's. (The diameter of

polythene pipe: Outer diameter 25mm Surface thickness ≥ 1.5mm)

• Drain hose should be short and drooping gradient should at less 1/100 to prevent the formation of air

bubble.

• If drain hose cannot has enough drooping gradient, drain raising pipe should be added.

• To prevent bent of the drain hose, the distance between hoisting stand should is 1 to 1.5m.

• Use the drain hose and clamp attached. Insert the drain hose to the

drain vent, and then tighten the clamp.

• Entwine the big sponge on the clamp of drain hose to insulate heat.

• Heat insulation should be done to indoor drain hose.

Diameter (inch) Surface thickness (mm) Tightening torque (N.m)

Ø 1/4" ≥ 0.5 15-30 (N.m)

Ø 3/8" ≥ 0.71 30-40 (N.m)

Ø 1/2" ≥ 1 45-50 (N.m)

Ø 5/8" ≥ 1 60-65 (N.m)

Ø 3/4" ≥ 1 70-75 (N.m)

(correct) 1/25 to 1/100 down-slope

(wrong)

Clamp (accessory)

Sponge (5Tx270x270) (accessory)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 159 160

Sin comentarios

Whirlpool AMD 385 Instrucciones de uso Pagina 30