Whirlpool EKB 3482/2481 Instrucciones de uso descargar pdf (Pagina 21)

96

2.1 Mounting in the hole the

metal leans supports

Use the metal leans support as a tool to help

you locate the position of the screw to fix the

flat eccentric roller. You should hang the metal

leans support as shown on Fig. 3A.

The semicircle cut indicate the center to mark

the screw position where to fix the flat eccen-

tric roller.

Turn the metal lean support keeping the sup-

port side on the outside position.

Fix the metal lean support and screw the flat

eccentric roller into the oval hole, at the start

tight slightly. The supplied screws can be

screwed according to material used (wood,

stone, etc.). the hole diameter depend on the

type of the material used.

After screwing the metal lean support, fix the

autoadhesive washer supplied (9x2 mm).

Introduce in the hole the glass ceramic hob

levelling the glass top to the working surface

operating the flat eccentric roller to adjust the

height.

Remove again the glass ceramic hob and screw

tightly the screws of flat eccentric roller.

With a cleaning agent, clean properly the bor-

der of the hob to remove any oil grease or oth-

er dirt.

Reinstall the glass ceramic hob in its hole and

adjust the spacing around the glass to be

evenly spaced on all sides. Press on the glass,

particularly on the angles in order to evenly

position the glass with the working table

around it Fig. 3B.

Attention: Don’t use any tool against the

glass borders.

INSTALLATION

Fig. 3A

Fig. 3B

Silicone

Hob borders

Flat eccentric roller

Metal lean

support

Working surface

min. 30 mm

Gasket 9x2

1 2 ... 16 17 18 19 20 21 22 23 24 25

Comentarios a estos manuales

Sin comentarios