Whirlpool HJA1733 Instrucciones de uso descargar pdf (Pagina 11)

Cook er care

Care & maintenance

Care and maintenance

Before cleaning, make sure the cooking zones are

switched off and that the residual heat indicator

(“H”) is not displayed.

• Never clean the hob with a steam cleaner!

• Periodically check for dust under the appliance,

near the cooling air inlet or the outlet openings.

This could hinder the ventilation and cooling of

the electronic module and decrease the

effectiveness of the hob.

Clean the hob after each use in order to avoid

damaging the surface and to prevent the formation

of baked-on deposits which are difficult to remove.

To clean the hob, proceed as follows:

1. Use a soft clean cloth, absorbent kitchen wipes or

a proprietary cleaner for glass ceramic hobs. Do

not use abrasive sponges and/or metal scouring

pads.

2. Food spills should be cleaned off before they bake

onto the glass ceramic surface. Sugar and foods

with a high sugar content damage the glass

ceramic surface and must be immediately

removed using a scraper for glass. Caution! Glass

scrapers have a very sharp blade and must be

handled with care.

3. Remove any stubborn food residues with a

scraper or proprietary detergents.

4. Salt, sugar and sand can scratch the glass ceramic

hob: clean up any such spills on the hob

immediately.

Troubleshooting guide

Before contacting After-sales Service

• Read and follow the instructions given in the

section “Operating the hob”.

• Connect the hob to the electricity supply and

check that the supply has not been shut off.

• Clean the hob and dry it thoroughly.

• If, when the hob is switched on, alphanumeric

codes appear on the display, consult the

following table for instructions.

WARNING

Error code Description Possible causes Remedy

The hob switches off

and after 30 seconds

emits an acoustic signal

every 4 seconds

Continuous pressure

on control panel area

Water or utensils on control

panel

Clean the control panel

C81, C82 The control panel

switches off because of

excessively high

temperatures

The internal temperature of

electronic parts is too high

Wait for the hob to cool

down before using it

again

F42 or F43 The connection

voltage is wrong

The sensor detects a

discrepancy between the

appliance voltage and that of

the mains supply

Disconnect the hob from

the mains and check the

electrical connection

F12, F21, F25, F36, F37,

F40, F47, F56, F58, F60

Call the After-Sales Service and specify the error code

1 2 ... 6 7 8 9 10 11 12 13

Comentarios a estos manuales

Sin comentarios

Whirlpool HJA1733 Instrucciones de uso Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool HJA1733