Whirlpool TM 7320 (NR) Instrucciones de uso descargar pdf (Pagina 16)

Ventilation

To allow adequate ventilation and to avoid overheating

of the surrounding surfaces the hob should be

positioned:

 At a minimum of

40 mm from the

back panel and 600

mm from any other

vertical surfaces.

 maintaining a

minimum distance

of 10 mm between

the installation

cavity and the

cabinet underneath

Fixing

The appliance must be installed on a perfectly level

supporting surface.

Any deformities caused by improper fixing could change

the features and the operation of the hob.

FRONT SIDE OF HOB

SUPPORTING

SURFACE

UNDERSIDE OF HOB

Fix the appliance as follows:

1. Use short flat-bottomed screws to fix the 4

alignment springs in the holes provided in the

centre of each side of the hob.

2. Insert the hob in the cavity, make sure it is in a

central position and push down on the whole

perimeter until the hob is stuck to the supporting

surface.

 The screws for the alignment springs must remain

accessible.

 In order to adhere to safety standards, the appliance

must not come into contact with electrical parts once it

has been installed.



All parts that ensure the safe operation of the

appliance must not be removable without the aid of a

tool.

Gas connection

The appliance should be connected to the main gas supply

or to a gas cylinder in compliance with current national

regulations. Before carrying out the connection, make sure

the cooker is compatible with the gas supply you wish to

use. If this is not the case, follow the instructions indicated in

the paragraph Adapting to different types of gas.

When using liquid gas from a cylinder, install a pressure

regulator which complies with current national regulations.

 Check that the pressure of the gas supply is consistent

with the values indicated in Table 1 (Burner and nozzle

specifications). This will ensure the safe operation and

longevity of your appliance while maintaining efficient

energy consumption.

Connection with a rigid pipe (copper or steel)

 Connection to the gas system must be carried out in such

a way as not to place any strain of any kind on the

appliance.

There is an adjustable L-shaped pipe fitting on the

appliance supply ramp and this is fitted with a seal in order

to prevent leaks. The seal must always be replaced after

rotating the pipe fitting (seal provided with appliance). The

gas supply pipe fitting is a threaded 1/2 gas cylindrical male

attachment.

Connecting a flexible jointless stainless steel pipe to a

threaded attachment

The gas supply pipe fitting is a threaded 1/2 gas cylindrical

male attachment.

These pipes must be installed so that they are never longer

than 2000 mm when fully extended. Once connection has

been carried out, make sure that the flexible metal pipe

does not touch any moving parts and is not compressed.

 Only use pipes and seals that comply with current national

regulations.

Checking the tightness of the connection

 When the installation process is complete, check the pipe

fittings for leaks using a soapy solution. Never use a flame.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comentarios a estos manuales

Sin comentarios

Whirlpool TM 7320 (NR) Instrucciones de uso Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool TM 7320 (NR)