Whirlpool PCCF 50201260 W Instrucciones de uso descargar pdf (Pagina 34)

315222

• Lacquer-coated, stainless steel, and zinc-coated surfaces,

as well as aluminum parts, should never come into contact

with oven cleaning sprays, as these may cause damage and

discoloration. The same applies for the thermostat sensor

(if the cooker features a timer with a probe) and the heaters

accessible at the upper part.

• When purchasing and dispensing detergents, consider

the environment and observe the instructions provided by

respective cleaning agent manufacturers.

Catalytic layer (only with some models)

• Catalytic enamel is soft and sensitive to mechanical stress;

therefore, the use of abrasive cleaners and sharp objects is not

recommended.

• Coarse catalytic enamel speeds up the disintegration of grease

and other types of impurity. Minor stains that remain after cooking

normally disintegrate by the time the oven is used for the next time.

In general, the stains will disappear at temperatures above 220°C,

while with lower temperatures they will disappear only in part.

• Self-cleaning power of the catalytic parts is weakened in tome. We

recommend replacing the layer after a few years of regular use.

Practical tip

• When cooking larger fatty chunks of meat, we recommend

wrapping them in aluminum foil of a suitable cooking bag, to

prevent the grease from being spattered on the oven interior

walls.

• When grilling meat on the grid, place a drip tray underneath.

Cleaning the oven interior ceiling (only with some models)

• To facilitate cleaning of the oven interior upper wall, some

appliances feature a foldable upper infra heater.

• Before lowering the heater, the cooker must be disconnected from

the power mains by removing the fuse or tripping the main switch.

• The heater should be cooled down; otherwise there is a risk of

burning!

• Do not use the heater when it is lowered!

Before cleaning the oven, remove the baking trays, the grid, and

the guides. Then, pull the horizontal heater towards yourself. Pull

the heater until the crossbar is released from the supports on the

left and right side of the oven (see ﬁ gure). After cleaning, replace

the heater following the same procedure; the crossbar must be

reinserted into the two support brackets.

Accessories

Wash the accessories (baking trays, grid, etc.) with hot water and

some conventional detergent.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Comentarios a estos manuales

Sin comentarios

Whirlpool PCCF 50201260 W Instrucciones de uso Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool PCCF 50201260 W