Whirlpool PCCF 50201260 W Instrucciones de uso descargar pdf (Pagina 7)

315222

Yellow lamp

The lamp is lit when any of the appliance functions are activated.

Red lamp

The red lamp is lit when heaters in the oven are operating; when

the selected temperature is reached, the lamp goes off.

Backlit knob dials

(only with some models)

The dial of an activated knob is lit when a function is selected.

Appliances with this feature do not have the yellow control lamp.

Set the time of day as described in the separate instructions for

the program timer, supplied with your appliance. Setting the time

of day is requisite for the use of the appliance. Oven operation is

only possible once the time of day has been set.

Maximum setting time is 60 minutes. After the set time has

elapsed, an audible signal is emitted, lasting approximately ﬁ ve

seconds. Select the countdown time roughly by rotating the

knob forward in the clockwise direction; then rotate it in the other

direction (anticlockwise) to ﬁ ne-tune the setting.

Switch-off timer enables settings from 0 to 120 minutes.

• Rotate the dial in the clockwise direction until the desired

time is selected. After the set time has elapsed, the selected

operation / heating mode is switched off.

• If you do not wish to use the switch-off timer, or if the

preparation time is shorter than 15 minutes (preheating,

preparing pizzas, etc.) or longer 120 minutes (for dishes

that require a longer cooking time), the manual setting is

recommended.

• For manual setting, rotate the knob to the left (anticlockwise)

to the

(hand) symbol. In the “0” position, the oven will not

operate.

Control lampsControl lamps

Program timerProgram timer

Mechanical minute timerMechanical minute timer

Switch-off timer - 120

minutes (timer switch)

Switch-off timer - 120

minutes (timer switch)

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Sin comentarios

Whirlpool PCCF 50201260 W Instrucciones de uso Pagina 7