Whirlpool TVL 642 IB Instrucciones de uso descargar pdf (Pagina 16)

 The screws for the alignment springs must remain

accessible.

 In order to adhere to safety standards, the appliance

must not come into contact with electrical parts once it

has been installed.

 All parts that ensure the safe operation of the appliance

must not be removable without

the aid of a tool.

Electrical connection

 The electrical connection of the hob and any built-in

oven must be carried out separately, both for safety

purposes and to make extracting the oven easier.

Terminal board

On the lower part of the

appliance there is a connection

box for the different types of

electricity supply (the picture is

only an indication and is not an

exact representation of the

purchased model).

Single-phase connection

The hob is equipped with a pre-connected electricity

supply cable, which is designed for single-phase

connection. Connect the wires in accordance with

the instructions given in the following table and

diagrams:

Other types of connection

If the mains supply corresponds with one of the

following:

Voltage and mains frequency

 380V +N ~ 50 Hz

 230V 3 ~ 50 Hz

 380V + 2N ~ 50 Hz

Connect the wires in accordance with the instructions

given in the following table and diagrams:

If the mains supply corresponds with one of the following:

Voltage and mains frequency

 400V 3 - N ~ 50 Hz

proceed as follows:

 The cable provided is not suitable for the following

types of installation.

1. Use a suitable supply cable, H05RR-F or higher, with

the

right dimensions (cable section: 25 mm).

2. To open the terminal board, insert a screwdriver into

the side tabs of the cover (see Terminal board picture).

3. Loosen the cable clamp screw and the terminal board

screws according to the type of connection required and

position the connection supports as shown

in the

following table and diagrams.

4. Position the wires according to the following table and

diagrams and connect the appliance by tightening all

the screws for the springs as much as possible.

5. Secure the power supply cable by fastening the cable

clamp screw, then put

the cover back on.

Three-phase 400

UNDERSIDE OF HOB

Voltage and

mains frequency

Electrical cable Wire connection

230V 1+N ~

50 Hz

: yellow/green;

N: the two blue wires

together

L: brown and black

together

Voltage and

mains frequency

Electrical cable Wire connection

400V - 2+N ~

50 Hz

230V 3 ~

50Hz

: yellow/green;

N: the two blue wires together

L1: black

L2: brown

400V - 2+2N ~

50 Hz

: yellow/green;

N1: blue

N2: blue

L1: black

L2: brown

Voltage and

mains frequency

Electrical connections Terminal board

400V 3-N ~

50 Hz

Three-phase 400

U-bolt

connection support

Phase PhasePhase Neutral Earth

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comentarios a estos manuales

Sin comentarios

Whirlpool TVL 642 IB Instrucciones de uso Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Whirlpool TVL 642 IB