Whirlpool ACM 227 IX Instrucciones de uso Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 175
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
36 /EN
8 Troubleshooting
Oven emits steam when it is in use.
It is normal that steam escapes during operation. This is not a fault.
Water drops occur during cooking
The vapour that arises during cooking can condense and form water droplets when it hits
cold surfaces of the product. This is not a fault.
Product does not operate.
The mains fuse is defective or has tripped. Check fuses in the fuse box. If necessary,
replace or reset them.
Buttons/knobs/keys on the control panel do
not function.
Keylock may be enabled. Please disable it.
(See. Using the keylock, page 28
If the display does not light up when you
switch the hob on again.
Disconnect the appliance at the circuit
breaker. Wait 20 seconds and then
reconnect it.
Overheat protection is active. Allow your hob to cool down.
The cooking pot is not suitable. Check your pot.
Oven light does not work.
Oven lamp is defective. Replace oven lamp.
Power is cut. Check if there is power. Check the fuses in
the fuse box. If necessary, replace or reset
the fuses.
Oven does not heat.
Function and/or Temperature are not set. Set the function and the temperature with
the Function and/or Temperature knob/key.
In models equipped with a timer, the timer
is not adjusted.
(In products with microwave oven, timer
controls only microwave oven.)
Adjust the timer.
Power is cut. Check if there is power. Check the fuses in
the fuse box. If necessary, replace or reset
the fuses.
(In models with timer) Clock display is blinking or clock symbol is on.
A previous power outage has occurred. Adjust the timer / Switch of the product and
switch it on again.
symbol appears on the cooking zone display.
You have not placed the pot on the active
cooking zone.
Check if there is a pot on the cooking zone.
Your pot is not compatible with induction
cooking.
Check if your cooking pot is compatible with
induction hob.
The cooking pot is not centered properly or
the bottom surface of the pot is not wide
enough for the cooking zone.
Choose a pot wide enough and center the
pot on the cooking zone properly.
Cooking pot or cooking zone is overheated. Allow them to cool down.
Selected cooking zone suddenly turns off during operation.
Cooking time for the selected cooking zone
may be over.
You may set a new cooking time or finish
cooking.
Overheat protection is active. Allow your hob to cool down.
An object may be covering the touch control
panel.
Remove the object on the panel.
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 174 175

Comentarios a estos manuales

Sin comentarios